ZyXEL Communications Network Router NOT AVAILABLE Manual do Utilizador descarregar pdf (Página 214)

Chapter 34 System Remote Management

NXC CLI Reference Guide

214

34.2 Common System Command Input Values

The following table identifies the values required for many of these commands. Other input

values are discussed with the corresponding commands.

34.3 HTTP/HTTPS Commands

The following table describes the commands available for HTTP/HTTPS. You must use the

configure terminal command to enter the configuration mode before you can use these

commands.

Table 125 Input Values for General System Commands

LABEL DESCRIPTION

address_object The name of the IP address (group) object. You may use 1-31 alphanumeric

characters, underscores(

_), or dashes (-), but the first character cannot be a

number. This value is case-sensitive.

rule_number The number of a service control rule. 1 - X where X is the highest number of rules

the NXC model supports.

zone_object The name of the zone. Use up to 31 characters (a-zA-Z0-9_-). The name cannot

start with a number. This value is case-sensitive.

The NXC uses pre-defined zone names like LAN and WLAN.

Table 126 Command Summary: HTTP/HTTPS

COMMAND DESCRIPTION

[no] ip http authentication auth_method Sets an authentication method used by the

HTTP/HTTPS server. The

no command resets

the authentication method used by the HTTP/

HTTPS server to the factory default (default).

auth_method: The name of the authentication

method. You may use 1-31 alphanumeric

characters, underscores(_), or dashes (-), but the

first character cannot be a number. This value is

case-sensitive.

[no] ip http port <1..65535> Sets the HTTP service port number. The

command resets the HTTP service port number

to the factory default (80).

[no] ip http secure-port <1..65535> Sets the HTTPS service port number. The no

command resets the HTTPS service port number

to the factory default (443).

[no] ip http secure-server Enables HTTPS access to the NXC web

configurator. The

no command disables HTTPS

access to the NXC web configurator.

[no] ip http secure-server auth-client Sets the client to authenticate itself to the HTTPS

server. The no command sets the client not to

authenticate itself to the HTTPS server.

[no] ip http secure-server cert certificate_name Specifies a certificate used by the HTTPS server.

The no command resets the certificate used by

the HTTPS server to the factory default

(

default).

certificate_name: The name of the

certificate. You can use up to 31 alphanumeric

and ;‘~!@#$%^&()_+[]{}’,.=-

characters.

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 299 300

Comentários a estes Manuais

Sem comentários

ZyXEL Communications Network Router NOT AVAILABLE Manual do Utilizador Página 214

Comentários a estes Manuais

Manuais e produtos relacionados com Software ZyXEL Communications Network Router NOT AVAILABLE