ZyXEL N300 Manual do Utilizador descarregar pdf (Página 45)

Chapter 6 Wireless LAN

WRE2205 User’s Guide

Note: WPS times out after two minutes of pressing a button. Press the button on the

second device within about a minute of the first, then wait two minutes for the WPS

configuration to complete.

To add the second wireless station, you have to press these buttons on both device and the wireless

station again after the first 2 minutes.

Figure 33 Network > Wireless LAN > WPS Station

The following table describes the labels in this screen.

6.10 AP Select Screen

Use this screen to choose an access point that you want the WRE2205 to connect to. You should

know the security settings of the target AP.

To open this screen, click Network > Wireless LAN > AP Select tab.

Table 17 Network > Wireless LAN > WPS Station

LABEL DESCRIPTION

Config Mode Use this to select Registrar or Enrollee mode. Select Registrar mode to make wireless

clients follow the wireless settings of the WRE2205. Select Enrollee mode to make the

WRE2205 follow the wireless settings of an access point.

Push Button Use this button when you use the PBC (Push Button Configuration) method to configure

wireless stations’s wireless settings. See Section 5.2.1 on page 26.

Click this to start WPS-aware wireless station scanning and the wireless security

information synchronization.

Input station’s

PIN number

Use this button when you use the PIN Configuration method to configure wireless station’s

wireless settings. See Section 5.2.2 on page 28.

Type the same PIN number generated in the wireless station’s utility. Then click Start to

associate to each other and perform the wireless security information synchronization.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 66 67

Sem comentários

ZyXEL N300 Manual do Utilizador Página 45