ZyXEL P-660HW-T v2 Manual do Utilizador descarregar pdf (Página 6)

P-660HW-T v2 Quick Start Guide

Enable OTIST only if your wireless clients support WPA and OTIST.

You must enable OTIST on the P-660HW-T v2 and all wireless clients (in any order) within three minutes.

To enable OTIST on the P-660HW-T v2, you can either use the wizard (see Section 3 on page 4) or hold in the

RESET button (see Section 1 on page 2) for three to eight seconds. Do not hold the RESET button in for too

long, as this will reset the P-660HW-T v2 to the factory defaults.

To enable OTIST on wireless clients, click Start in the Adapter screen. The Setup Key is 01234567 by default.

If you have previously saved a setup key on the P-660HW-T v2, use it instead of the default.

For more information, see Wireless LAN in the User's Guide.

Troubleshooting

1 If you cannot access the web configurator using Internet Explorer in Windows XP or Windows Server 2003,

make sure you allow pop-up windows, JavaScripts and Java permissions or set the Internet security level

lower than High in Internet Explorer (in Internet Explorer, click Tools > Internet Options > Security >

Custom Level...). See the appendix in the User’s Guide for more information.

2 If you cannot access the Internet when your computer is connected to the ETHERNET port, follow these

steps.

A) Check the lights on the front panel. If they are different from what is described in section 1, make sure

the P-660HW-T v2 is correctly connected. (See section 1.) If the lights are still different, turn off the

device, wait a few seconds, and turn it on again.

B) Follow the steps in section 3 again. Make sure you enter the correct information. For example, if your

account has a user name and password, make sure you type it correctly. In addition, if you are not sure

which encapsulation your ISP uses, contact your ISP.

C) If you are using a new Internet account, contact your ISP to make sure it is active.

D) If you still have problems, see Troubleshooting in the User’s Guide.

3 If you cannot access the Internet using the wireless network, follow these steps.

A) On a computer in the wireless network, open your browser, and go to http://192.168.1.1. If you see the

screen in step 3 of section 3, follow suggestions A - D above. If you do not, go to the next step.

B) Make sure your P-660HW-T v2 and your computer are using the same wireless and wireless security

settings. Follow the steps in section 3.

Viewing Your Product’s Certifications

1 Go to www.zyxel.com.

2 Select your product from the drop-down list box on the ZyXEL home page to go to that product's page.

3 Select the certification you wish to view from this page.

1 2 3 4 5 6

Sem comentários

ZyXEL P-660HW-T v2 Manual do Utilizador Página 6