ZyXEL ACCESSING INTERNET & INTRANET omni series Manual do Utilizador descarregar pdf (Página 88)

76 Handling Analog Calls (non-data)

InterCom: ( ñ è H Flash è H #2

Call Waiting

The call waiting feature enables you to place a call on hold by

pressing the Flash key. If you press the Flash key again, the call

waiting function will be disabled and return to the previous call.

Call Waiting: H Flash

Placing a second call

When you have an active call on line, you may follow the procedures

below to make a second call:

1. Place the current call on hold by pressing the Flash key and 0.

2. Dial the phone number of the second party and wait for them to

answer.

Making a second call: H Flash è H #0 è H “555-1234”

Receiving a second call

If call waiting has been enabled, you will receive a signal through the

handset whenever a call is trying to come in while you are on-line. To

enable the call waiting function, use the AT Commands in the table

below:

AT Commands Description

ATS79.2=0 Disables call waiting for POTS port 1.

ATS79.2=1 Enables call waiting for POTS port 1(Default).

ATS79.3=0 Disable call waiting for POTS port 2.

ATS79.3=1 Enable call waiting for POTS port 2 (Default).

Note: If you disable the call waiting function(S79.2=0 or S79.3=0), the

second incoming call will be blocked.

Note: If you configure the POTS port for Modem/Fax connection

(S79.4=1 or S79.5=1), the call waiting feature of the respective

POTS port will be always disabled.

There are several ways to deal with a second incoming call:

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 167 168

Sem comentários

ZyXEL ACCESSING INTERNET & INTRANET omni series Manual do Utilizador Página 88